nicilaskin — rings

I was procrastinating today a bit and those 2 rings are the results I am actually supposed to work on fathers day orders but for some reason I got side tracked i used galery wire for the so called bezel setting wrapped once around the stone tightly to make the setting soldered the ends together so they form a ring place the stone inside there is a lot of forming going on with you fingers so that the stone sits tight but can be taken out without loosing the shape of the bezel I traced around the bezel to make...

wedding bands i made   www.nicilaskin.etsy.com I cut 2 different width flat wire stock to length 5mm and 4 mm width stamped the infinity symbol filed the ends flat and formed them so the ends meet flush add flux and solder start heating with a torch quench in water and then clean in pickle solution the black is oxidation that happens during torching after the pickle bath now start forming use a ring mandrel and a nylon hammer first after forming the ring you can use a ball peen hammer to make the dimpled texture , polish the inside I...

wings on sterling draw some narrow wings on a piece of paper stick/glue the wings to your metal sheet I am using 20 gauge brass ( 0.8mm thick ) I usually do a mock up in metal that is cheaper before doing a sterling/gold version draw your ring shank onto sterling silver this is 18 gauge ( 1 mm thick ) cut out your wings and your ringshank via jewelry saw and 1/0 saw blades make sure the ring shank and the wings fit ( I am good with eyeballing things - I tend not to measure ) solder your...

three hearts 3 metal hearts :) I used copper ,brass , sterling silver cut 3 hearts in different sizes from different metals mine are copper, brass , sterling silver cut sterling silver wire to make your ring shank silver wire ,or metal wire is the best you can use for ring shanks , the width is always consistent and its a lot less work mark with your makers stamp and 925 for the sterling bend your ring shank until the ends meet flux and add solder - heat with a torch until the solder flows The solder will flow when...

    When my husband and I had our first wedding anniversary I was the whole day in school studying for the NCLEX ( National Nursing Exam ) to be able to working the USA . I had been a nurse for 4 years in Germany but you still had to take an exam in order to come here and work. I was sad that I had to be in school the whole day . He picked me up at about 6 pm with the car . We drove home through the woods and he said to close the windows...