Menu
Cart 0

nicilaskin — seahorse

Sterling silver seahorse pendant

Posted by 36877008 on

This project was fun and very cute .I used 18 gauge sterling silver again . Draw your seahorse on a piece of paper and stick it onto your metal sheet . Cut out with your jewelry saw and 1/0 saw blades. Cut also the base of your pendant - I chose a dogtag shape. After cutting out your shapes make sure everything fits well together . Sand down with sand paper to clean the metal before soldering. Flux the back of your seahorse and add solder . Heat with torch until the solder flows ( melts ). Quench in water...

Read more →