Menu
Cart 0

nicilaskin — bracelets

Rock and Roll fo your arm

Posted by 36877008 on

  Sterling silver " Rock and Roll " cuff bracelet   I used a 20 gauge 6 inch by 1 1/4 inch strip of sterling silver for the base and 18 gauge sterling silver for the guitars and the star. The shapes were cut out with a 6 inch jewelry saw and 1/0 saw blades. Personally I prefer the german saws and saw blades as I found the quality to be outstanding , but I might be biased because I am german. I used a template to draw the guitars right on the metal and then sawed them out ....

Read more →

heart bracelet

Posted by 36877008 on

anticlastic bronze cuff with copper hearts cut a 1 1/4 or 1 1/2 inch wide strip from 20 gauge bronze cut lots and lots of hearts from copper I have a heart cutter from swanstrom , flux the back of your hearts and add solder I use hard wire solder for that heat the hearts until the solder melts and then flux the bronze strip and solder the hearts to it quench in water form your bracelet Now I realize that not everybody has a metal press with the anticlastic / synclastic former ,so you can make the bracelet normal...

Read more →

Copper Bird Bracelet

Posted by 36877008 on

  This is actually a very simple thing to make . You start out with a wide copper strip ,I used 1 1/2 inch  by 16 inch17 gauge copper for this cuff bracelet .  Draw your bird onto the bracelet strip or on a piece of paper . Pierce the inside of the wings and the inside of the birds body and cut out the bird. When you are done with cutting out file the edges nice and smooth . Form your bracelet on a mandrel either oval or round until you are satisfied with the shape . Start polishing...

Read more →

butterfly garden bracelet

Posted by 36877008 on

  this is just something to show you what one can do with old fashioned tools and 2 hands . I have no tutorial for that one as that bracelet took the whole day and was rather complicated and needed my whole attention . Hope you like it.   www.nicilaskin.etsy.com   nici

Read more →

Sterling silver dragonfly cuff bracelet

Posted by 36877008 on

I love dragonflies , who doesn't ? This is a more advanced project and you will need a bit more experience to make this one. Again I used 18 gauge ( 1mm thick ) sterling silver for that one . I cut a 1 inch wide and 6 inch long strip from sterling silver . The wings were drawn onto label paper for a printer and then stuck to 18 gauge sterling sheet . I used a 6 inch jewelry saw frame with 1/0 saw blades . The 6 inch saw frame is the one I use almost always to...

Read more →