Menu
Cart 0

nicilaskin — tutorials

Flower Ring with Amber

Posted by 36877008 on

the prongs get pushed with a bezel pusher over the stone finished ring with the bangle I made too well actually I made the bangle first a couple of days ago , but I wanted a ring too hope you like it

Read more →

guitar bypass ring

Posted by 36877008 on

made this today - gold bypass ring in shape of a guitar I started with a mock up in bronze ( much cheaper ) 20 gauge ( 0.8mm thick ) is what I use i bronze or gold as I have a hard time bending things by hand with those 2 metals 18 gauge ( 1mm thick ) I use for copper and sterling silver as both metals are softer and not as springy I drew the shape out on a piece of label paper make it 3 inches long as you have to "bypass " the ends and anything...

Read more →

fresh from the bench

Posted by 36877008 on

  So today I decided to work with some gold filled material . Gold filled metal is a much cheaper alternative than gold but of much higher quality than gold plated . The one I used is 14/20 meaning 5% off the metal is 14karat gold . The core is made of brass. The difference between gold plated and gold filled is the quality and the thickness of the layer while with gold plated you only get a microscopic film of 14k gold the gold filled layer is much thicker and bonded to the core via heat and pressure making...

Read more →

infinity wedding bands

Posted by 36877008 on

wedding bands i made   www.nicilaskin.etsy.com I cut 2 different width flat wire stock to length 5mm and 4 mm width stamped the infinity symbol filed the ends flat and formed them so the ends meet flush add flux and solder start heating with a torch quench in water and then clean in pickle solution the black is oxidation that happens during torching after the pickle bath now start forming use a ring mandrel and a nylon hammer first after forming the ring you can use a ball peen hammer to make the dimpled texture , polish the inside I...

Read more →

cuff links

Posted by 36877008 on

skull cuff links - a small how to :) www.nicilaskin.etsy.com Cut out 2 discs you want to make them at least 1 inch or the cuff links will be to small . I use a disc cutter but you can also cut them by hand with a jewelers saw draw your skulls on a piece of paper and stick to your metal sheet I used 20 gauge sterling silver for both the discs and the skulls ,I want to dome the cuff links later and when you go thicker they will dome funny cut out your skulls and punch holes...

Read more →